Page 1 of 1
WTB: Replacement rubber feet for K&M floor stand
Posted: Thu Sep 24, 2026 5:38 am
by PRO
Need a dozen rubber feet to replace the worn-out feet on my three K&M floor stands model 14940. These feet have a rectangular inside hole, dimensions approx 20mm x 6 mm (3/4" x 1/4"). Thank you.
Re: WTB: Replacement rubber feet for K&M floor stand
Posted: Tue Sep 29, 2026 7:57 am
by PRO
Update:
I read dp's recent posting (
viewtopic.php?t=14859&sid=7fe985cca1eab ... 107c702fe4) with interest. I have been having a similar experience.
Also note that my above message was viewed more than 700 times with zero response.
So I went to Lowe's and bought a 4-pack of 1" round furniture feet, slipped them over the existing-but-badly-worn K&M rubber feet, cross-drilled and pinned the rubbers so they won't slip off, e voila !!! New feet that won't scratch the floors -- at low cost and low wait-time.
Re: WTB: Replacement rubber feet for K&M floor stand
Posted: Tue Sep 29, 2026 8:06 am
by arpthark
PRO wrote: Tue Sep 29, 2026 7:57 am
Update:
I read dp's recent posting (
viewtopic.php?t=14859&sid=7fe985cca1eab ... 107c702fe4) with interest. I have been having a similar experience.
Also note that my above message was viewed more than 700 times with zero response.
So I went to Lowe's and bought a 4-pack of 1" round furniture feet, slipped them over the existing-but-badly-worn K&M rubber feet, cross-drilled and pinned the rubbers so they won't slip off, e voila !!! New feet that won't scratch the floors -- at low cost and low wait-time.
Nice going!
Re: WTB: Replacement rubber feet for K&M floor stand
Posted: Tue Sep 29, 2026 8:07 am
by the elephant
Pics, Paul?