WTB: Replacement rubber feet for K&M floor stand

[PRO]

Need a dozen rubber feet to replace the worn-out feet on my three K&M floor stands model 14940. These feet have a rectangular inside hole, dimensions approx 20mm x 6 mm (3/4" x 1/4"). Thank you.

[PRO]

Update:

I read dp's recent posting (viewtopic.php?t=14859&sid=7fe985cca1eab ... 107c702fe4) with interest. I have been having a similar experience.

Also note that my above message was viewed more than 700 times with zero response.

So I went to Lowe's and bought a 4-pack of 1" round furniture feet, slipped them over the existing-but-badly-worn K&M rubber feet, cross-drilled and pinned the rubbers so they won't slip off, e voila !!! New feet that won't scratch the floors -- at low cost and low wait-time.

[arpthark]

Update:

I read dp's recent posting (viewtopic.php?t=14859&sid=7fe985cca1eab ... 107c702fe4) with interest. I have been having a similar experience.

Also note that my above message was viewed more than 700 times with zero response.

So I went to Lowe's and bought a 4-pack of 1" round furniture feet, slipped them over the existing-but-badly-worn K&M rubber feet, cross-drilled and pinned the rubbers so they won't slip off, e voila !!! New feet that won't scratch the floors -- at low cost and low wait-time.

Nice going!

[the elephant]

Pics, Paul?